Hi. I am trying to run a CFD analysis and I have an internal window (located in an inter-block partition) through which I wish there was no air flow. The problem is that, when I select that window and go to the CFD tab, Designbuilder does not allow me to set the "Aperture size (% total opening area)" to 0%. It shows an error message, mentioning that the minimum value for that value has to be 5%.
Even though I set the "Flow in" and "Flow out" to 0, when I run the CFD simulation, it shows an opening in the window and the air flowing through it.
I really don't know what to do and I would appreciate any sort of help.
The version I am currently using is the DB 3.4.0.041
Forum for DesignBuilder CFD users to exchange views and ask each other questions
Moderator: DesignBuilder Support
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests