I am doing Internal CFD analysis and I have some queries regarding the internal loads and boundary conditions:
- I did hourly simulation (with internal loads) and imported E+ simulation results to get the boundary conditions. Now, while doing the internal CFD analysis, should I make internal equipments?
- The single zone has ventilators and exhaust fans (no air conditioning) and I want to simulate both cases when exhaust fans is not operational and when it is operational. Is it OK if I change the air flow through the ventilators to do the CFD analysis for the case when exhaust fans are operational OR should I make CFD boundary (supply/extract)? Again in this case to get the boundary conditions, should I run the E+ simulation with defined air change rate due to exhaust fans?
Thanks in advance.
Forum for DesignBuilder CFD users to exchange views and ask each other questions
Moderator: DesignBuilder Support
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests